Kippzonen COMBILOG Data Logger Manual de usuario descargar pdf (Pagina 70)

Channels settings

In order to change the values the press/rotary knob must be

pressed. Thereby a cursor will be set on the first character of

the value. Pressing the knob again moves the cursor one char-

acter to the right. The value at the place of the cursor can be

altered by turning the knob. Clockwise (=upwards) or counter-

clockwise (=downwards).

Note: Depending on the type of channel different settings can

be made.

(1) the definition of offset and factor is possible for the ana-

logue input channel, the digital input channel and the digit-

al output channel. These settings are used to convert the

measurement value from the unit of the measured value to

the unit of the measurement display.

(2) For the setpoint channel a setpoint value can be defined

if this is allowed by the configuration software

COMBILOG.EXE. This value can be used by the data log-

ger for further processing (e.g. for the arithmetic channel).

For the arithmetic channel and the alarm channel no settings

can be made.

Hardware Manual COMBILOG 1022

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 172 173

Sin comentarios

Kippzonen COMBILOG Data Logger Manual de usuario Pagina 70