Kippzonen 2AP Sun Tracker Manual de usuario descargar pdf (Pagina 12)

INSTALLATION AND SETUP

3 SAFETY INFORMATION

3.1 POWER SUPPLY AND FUSE RATINGS

Important: Power supply

Prior to turning the 2AP (115/230 VAC version) power on, ensure that the voltage selection

switches for main power and for the optional heaters (figure 3.1) are in the correct positions to

match the incoming power supply and that the appropriately rated fuses are fitted.

As the voltage selection switches are located on the power board ensure that the 2AP power is

turned off before continuing. Use a screwdriver to turn the 115/230 VAC switches as necessary.

Although the switches on the power board read 110/220V, they are suited to 115/230 mains

voltage, respectively. The switches are qualified for equipment of protection class II VDE 0630 (6.3

A/250 V). The mains voltage and fuse ratings for 115/230 VAC and 24 VDC are shown in table 3.

The fuses are according to IEC 60127-2, VDE, UL. The location of the fuses on the power board is

given in figures 3.2 and 3.3.

Figure 3.1: 115/230 VAC Power Switch Diagram.

Table 3: 2AP Power Supply and Fuse Ratings (slow-blow type).

230 VAC 115 VAC 24 VDC

Power supply ±10% VAC ±10% VAC 23-26VDC

F1 mains power 0.25A (slow) 0.5A (slow) 3.15 A (slow)

F2 heater kit 0.5 A (slow) 1 A (slow) 1 A (slow)

F2 extreme heater kit 1 A (slow) 2 A (slow) 2 A (slow)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 109 110

Sin comentarios

Kippzonen 2AP Sun Tracker Manual de usuario Pagina 12