Kippzonen 2AP Sun Tracker Manual de usuario descargar pdf (Pagina 28)

INSTALLATION AND SETUP

Figure 4.7: 2AP Bottom Flange Dimensions.

When the 2AP is set up as a Suntracker the "E" label on the shaft and arrow on the bottom flange of

the 2AP must

be facing geographical East. Preliminary orientation will do at this stage of the Setup.

How to fine-tune the Azimuth orientation of the 2AP will be explained later on, in the Sighting

Adjustment Procedure.

Tip: For now, when installed as a Suntracker an initial Azimuth orientation due East with the

help of a compass will do. In the Home Position the 2AP Zenith axis is perpendicular to

the "E" label on the Azimuth shaft. So with the "E" label pointing due east, the Zenith axis

is pointing North-South.

Note: When the 2AP is used as Positioner only

the 2AP does not necessarily need to be

mounted facing the East. See section 4.7 of this manual for full information about the

different mounting and configuration possibilities for the Positioner purpose.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 109 110

Sin comentarios

Kippzonen 2AP Sun Tracker Manual de usuario Pagina 28