Kippzonen 2AP Sun Tracker Manual de usuario descargar pdf (Pagina 45)

INSTALLATION AND SETUP

Figure 4.29: Sun Sensor Wire Connections.

Tip: It may be helpful to temporarily disconnect the connector from the PC board to install the

pins. A pin insertion & extraction tool is included to aid in this step (or removal, if required).

4.5.5.2 Setting Sun Sensor Parameters

The Sun Sensor is provided with a four-quadrant photodiode. Each quadrant has its own calibration

factor. To access the relevant page to set the Sun Sensor parameters, the optional Sun Sensor

needs to be selected in the “Post Delivery Check” in the Win2AP software. Selecting it will make

page 7 of the “Suntracker Setup Procedure” become accessible. Enter the Sun Sensor serial

number and the four calibration parameters in the designated boxes, see figure 4.30. Pressing the

“Save Sun Sensor Parameters” button will save the parameters into the 2AP.

Figure 4.30: Setting Sun Sensor Parameters

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 109 110

Sin comentarios

Kippzonen 2AP Sun Tracker Manual de usuario Pagina 45